LTM 1110-5.2 Dynamic AutoCAD Block (DWG)

The LTM 1110-5.2 dynamic block is a fully parametric AutoCAD DWG drawing of the Liebherr LTM 1110-5.2 mobile crane, drawn 1:1 by an Appointed Person. Built-in drop-down menus drive the main configuration changes, such as boom and counterweight, updating the geometry instantly for accurate lift plans, lift studies and site layouts.

About the LTM 1110-5.2

The LTM 1110-5.2 is a 5-axle Liebherr all-terrain mobile crane, widely used by crane hire companies for general lifting on construction, industrial and infrastructure sites. Capacity, boom and configuration details for any specific lift should be confirmed by a qualified Appointed Person against the manufacturer’s load charts.

What’s included in the LTM 1110-5.2 DWG

• Plan and elevation views of the LTM 1110-5.2, drawn 1:1 in model space
• Carrier, outriggers, superstructure, counterweight and main boom
• Outline ground-bearing footprint for checking outrigger positions
• Clean layer structure, ready to drop into your own lift plan template
• Works in AutoCAD and AutoCAD LT

How to use the LTM 1110-5.2 CAD block

Insert the DWG into your drawing in model space at 1:1. Select the block and use the dynamic grips or the Properties palette to set the boom and counterweight configuration, then rotate the crane in plan to suit the site. Because the outriggers and footprint are drawn to scale, you can check clearances, set-up positions and ground-bearing areas directly on the site layout.

Who the LTM 1110-5.2 block is for

The block is built for Appointed Persons, lift planners, crane hire companies and contractors who prepare lift plans and method statements and want a consistent, professional LTM 1110-5.2 drawing without redrawing the crane every time.

Looking for a similar crane? See the LTM 1100-5.1 dynamic block and the LTM 1130-5.1 dynamic block, or view all crane CAD blocks (DWG).